Tiger Gold, Thanks for your reply and insights. I have concluded a failed turn signal switch and have ordered a replacement. Once this is installed I will verify the low volt reading at that one location. I am thinking that it could be from the gas gauge sending unit therefore, the lower voltage however, it is an off the sleeve guess. I am hoping the new switch does the trick since there were noby Paul01 - Pontiac GTO Forum
Hi, Wish to ask the group an electrical question. 66 GTO conv., no brake lights, tail and signal working, brake switch ok. Traced wire after brake switch to curved connector near steering column where it goes from white (after brake switch) to black with white tracer after curved connection, then up steering column to turn signal switch. Now, here's where I am guessing a bit. Wires from curvby Paul01 - Pontiac GTO Forum
Thank you for your response. I haven't viewed this site since before your post. I am not aware of the numbers you described but, I will look for them and post any info obtained. Good luck with your restoration.by Paul01 - Pontiac GTO Forum
Would like to know if anyone has tips on restoring a 66 GTO 4sp console. I know the obvious sections are chrome but the area between the ribs is black. Is this a particular paint and is there a particular primer needed also? Any info would be much appreciatedby Paul01 - Pontiac GTO Forum
I have a 4 sp console (66) that I would like restored. The vinyl is fine but, I would like the top surface restored. Does anyone know of a source for this type of work? I am also trying to locate doorskins for the same year. Any help is much appreciated. Paulby Paulo1 - Pontiac GTO Forum
Lee and Travis, Thanks for your replies, your comments are a great help and much appreciated Paul.by Paul DeLandra - Pontiac GTO Forum
Hello to the Group, My name is Paul and I have a 66 GTO Conv. I am resuming a restoration that had been put on hold for the past 11 years. I have some questions regarding an install of a new gas tank and would hope someone in the Group could help. 1) Should the support straps have some kind of insulator to eliminate the metal to metal contact with the tank? 2)Is there a particular way that the taby Paul DeLandra - Pontiac GTO Forum